aMG USB Converter-N
|
|
|
|
|
aMG USB Converter-N Adapter
|
|
|
|
|
aMG USB Converter-N2
(aMG USB Converter-N Adapter + aMG USB Converter-N)
|
|
|
|
|
Features
| 1. | Implement the FTDI Chip: FT2232H Dual High Speed USB to Multipurpose UART/FIFO IC |
| Single chip USB to dual serial / parallel ports with a variety of configurations |
| Entire USB protocol handled on the chip. No USB specific firmware programming required |
| USB 2.0 High Speed (480Mbits/Second) and Full Speed (12Mbits/Seconds) compatible |
| Dual Multi-Protocol Synchronous Serial Engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI or bit-bang) design |
| Dual independent UART or FIFO or MPSSE ports. Independent Baud rate generators |
| Fast Opto-Isolated serial interface option |
| Free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases. Adjustable receive buffer timeout |
| Independent Baud rate generators |
| RS232/RS422/RS485 UART Transfer Data Rate up to 12Mbaud. (RS232 Data Rate limited by external level shifter) |
| UART Interface supports 7/8 bit data, 1/2 stop bits, and Odd/Even/Mark/Space/No Parity |
| +3.3V I/O interfacing (+5V Tolerant) |
2. Extended -40°C to 85°C industrial operating temperature range
3. MatlabTM/SimulinkTM block support
| Fast Serial Blocks enable up to 1kHz closed-loop Simulink HIL Simulation |
4. ROHS Compliant
Usage Note
| 2. | Virtual COM Driver distributed with this version of Waijung. |
| 3. | When using the aMG USB Converter - N2 with aMG F4 Connect 2 use Channel - A (the first COM port from Hardware Device Manager List) |
Applications
| 1. | Generic 2 Ports USB - Serial/SPI/I2C Converter |
| 2. | Hardware in the Loop Simulation and Test |
Documentations
